SCHLAGE ELECTRONIC DEADBOLT HOW TO
You must do this procedure within ten seconds only.ĭid you find our tutorial on how to program a Schlage deadbolt lock helpful? You can only maximize the security of your schlage deadbolt lock if you know how to program it. Push the button again until its light turns green and beeps. Push the button with the word “Schlage” then reattach the battery. You can reboot the lock and restore the Programming Code’s default by disconnecting its battery. What can I do if I forgot my programming code? However, you will still hear this sound when you are programming the lock. Once finished, press 5 to turn off the beeping sound of the lock. Then, press “Schlage” again so the keypad flashes a blue light.
SCHLAGE ELECTRONIC DEADBOLT CODE
You just need to key in the programming code of the lock and wait for the Schlage knob to flash orange and beep thrice. Is there a way that I can stop my lock from beeping?įortunately, yes. If the lock still does not work properly despite the reinstallation, you may contact the customer service of Schlage. Make sure that it is perfectly placed and aligned. If this happens, it means that your lock is not correctly installed. A green blinking light will flash to indicate that you have added a user code. Wait again for the orange light to flash and beep thrice. Now, you can enter the updated User Code.
To add a user code, you have to press 1 on the keypad then wait until the Schlage button flashes an orange light and beeps thrice. After that, you can push this button again and proceed to the next step. Then, wait for the Schlage button to flash an orange blinking light thrice and beep. If you want to add User Codes to share with your family members and close friends, you have to enter your updated programming code first. You will use your new Schlage programming code in changing, adding, and deleting user codes. Do the procedure again in case this happens. If a red light flashes, it means that there was an error in programming. You have to re-enter your updated programming code.Ī green blinking light followed by a beep will indicate that you successfully changed your programming code. The Schlage button will flash an orange light and beep thrice. After that, enter your new six-digit programming code. The button will flash orange light thrice and beep.īefore you enter your updated programming code, you must write it down in case you forget it. If you entered the correct programming, an orange blinking light will flash thrice and you’ll hear three beeps. Once you have located your programming code, enter it by punching the numbers on the lock Schlage keypad. In case you changed the programming code and forgot it, you have to reset the lock to its factory setting. If you are a new user of Schlage deadbolt locks, you can locate the programming code in the places we mentioned earlier.
A user code, on the other hand, can consist of four digits. A programming code is different from a user code. Whether you want to change, add or delete a user code, you will need to have your programming code first. If you cannot find the former user of the lock, you can reset it to factory settings to restore the Programming Code’s default. If it’s previously owned, you need to acquire the current programming code from the former user.
You must take note of it before proceeding to Schlage keypad programming. You may find it in front of the user manual, on the stickers of the lock, and at the keypad assembly’s rear end. If it’s a new Schlage deadbolt lock, you need to locate its programming code. It is easy to find, and would only take a few minutes to locate.
What can I do if I forgot my programming code?īefore you program Schlage deadbolt, there is one thing that you need to prepare beforehand. Is there a way that I can stop my lock from beeping? Step 3: Adding Schlage smart lock change code.